Floor paint construction process
#1
There must be a lot of sundries and dust in the area where the basic treatment has just been renovated. Therefore, the ground should first be cleaned with a grinder to provide a clean environment for the construction of the floor paint, so that the ground can be used after the completion of the work. The lacquer and the surface can be fully bonded together. Scratch theoutdoor cooler from composite materials epoxy primer before applying the floor paint, you should first use the primer to increase the adhesion of the paint layer, because the surface of the brushed floor will be uneven, especially in some rough places, there will be A large number of gaps and small holes, etc., so after the surface of the floor is cleaned, the epoxy seal primer should be applied first, so as not to affect the construction effect of the floor paint.
It takes about germany decking a week to complete the maintenance and repair, and then it can be put into normal use, because a certain amount of volatile organic compounds will be released during the construction and curing process, so it must be cured before use. Precautions for the construction floor paint Because the general paints are made of synthetic resin, and the synthetic resin paint has a low ignition interlocking plastic patio tiles point, which is the main cause of many dangerous accidents such as explosions and fires.
Therefore, be sure to stay away from the fire during construction. During the construction, the solvent is volatile and fat-soluble, which will be absorbed by our skin and excreted slowly. Therefore, it is best not to make long-term contact during construction to avoid the reduction of anal function. When buying floor paint, it is best to go to the more famous big brands to buy, to prevent the poor quality of the purchase, not only the product does not have security, not long-term, and may can composite decking be used inside endanger their own health.
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Oil And Gas Process Software'20 dvdget3 0 307 10-28-2020, 10:31 AM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 343 10-27-2020, 01:41 PM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 331 10-14-2020, 01:05 AM
Last Post: dvdget3
  tecnomatix v14.02 Process Simulate Designer dvdget3 0 329 10-13-2020, 11:28 PM
Last Post: dvdget3
  TWI RiskWISE 5 for Process Plant v5.1.0.28350 dvdget3 0 308 10-12-2020, 02:05 PM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 308 10-12-2020, 02:39 AM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 273 10-11-2020, 02:19 PM
Last Post: dvdget3
  tecnomatix v14.02 Process Simulate Designer dvdget3 0 297 10-11-2020, 12:33 PM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 292 10-10-2020, 06:04 AM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 247 10-08-2020, 10:13 PM
Last Post: dvdget3

Forum Jump:


Users browsing this thread: 1 Guest(s)