Domain Social Forums

Full Version: gypsum board transfer to be inverted
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
see the structure, look at the corner, see the curvature, see stare, see the flatness, see symmetry. First, the acceptance of woodwork standards 1, gypsum board and gypsum board transfer to be inverted V-shaped stitching, seam width 5mm to 10mm and consistent. 2, gypsum board appearance without pollution, split, missing edge, angle, hammer, defects. 3, gypsum board ceiling at the corner can not be sewn, corner must be "7" type cut. Second, the woodworking
acceptance method 1, to see the gap wood sealing line, angle, waist line decorative panels do not touch the mouth of more than 0.5mm, line and line clip mouth seam does not exceed 0.5mm, decorative panels and board no more than 0.5mm .2, see if the structure is straight. Regardless of the horizontal direction or vertical direction, the correct carpentry practice should be straight flat. 3, to see whether the corner angle is accurate. The normal corner is 90 degrees,
except for the special design factors. 4, see radian radians and roundness is smooth, smooth. In addition to a single, the same shape of the same shape to ensure the same. 5, to see nail eye ceiling structure used by the nails, need to be painted on the nail eye rust paint. 6, see the flatness should ensure that the surface of the woodworking project is smooth, no drum or broken. 7, see symmetry symmetry woodworking project is symmetrical. Attachment: woodworking
patio flooring ideas in Finland
outdoor vinyl floor price
pvc plastic sheet making Egypt